HELP…. Situation: Older Macintosh (Power Mac)….connected to and EXTERNAL SCSI Drive via those old Thick SCSI Cables. Well….the SCSI Connection interface WITHIN the external drive enclosure has failed. HOWEVER….I was able to get the drive itself out and connect it to an external power ...

BIOS Boot error 0189 invalid RFID conifguration information area I keep getting this message at the boot up and its driving me mad, how do i go around this or correct it??????

I have a Thinkpad R61 which displays the following error on boot up: ERROR 0210: stuck key 44 Press <F1> to SetUp On entering BIOS, selecting ‘Restart’ normally gets the PC to boot. but i notice that some of the direction keys ...

Hi Everyone, I was just wondering if there is a difference between two USB cables having same set of connectors, but having different thickness. Actually, the USB Cable for my WD 500 GB External Hard Drive got damaged. I tried replacing the ...

hi guys iv got a bit of a odd problem and hoping for some ideas. my laptop was obviously over heating as the fan started to rev up and down. so i took of the heat sink and fan.cleaned everything ...

Have cleaned all dust out, checked connections, no leakage seen. Have replaced 3v lithium battery. When I switch on machine beeps, lights up, fan works etc but nothing on monitor screen. Just says “no input detected” & goes to powersave. ...

pentium 4 cpu 1400mhz 1.38 ghz with 512 ram right now using 4, 128 sticks

I am very new at the computer and just learning. I keep getting the message that my pc would run faster if i change the usb composite device to a different port? Where is the ports located? I have a ...

Everytime i try to download a scan tool or registry tool anything it doesnt matter what it is my computer keeps saying it cannot open it because its disabled or does not have enabled devices to go with it an ...

I will try to explain my problem as short as possible. I was using a UPS which always get into trouble. I went to local UPS service guy, who suggested to change the board(PCB). so, i accpected and he change to ...